Home › Suspension › SUSPENSION CONTROL › STABILIZER CONTROL VALVE(w/ KDSS) › 2015.06–2020.08
RM27T0E _53 Suspension _053706 SUSPENSION CONTROL _0260872 STABILIZER CONTROL VALVE(w/ KDSS) A

SUSPENSION CONTROL  STABILIZER CONTROL VALVE(w/ KDSS)  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



Hide 48826D 3.REMOVE STABILIZER CONTROL VALVE PROTECTOR

a.
C212853

Remove the 2 bolts and stabilizer control valve protector.


Hide 4.DRAIN SUSPENSION FLUID

a.
C212854

Loosen the bleeder plug on the stabilizer control with accumulator housing assembly and drain suspension fluid.

HINT:
·

Drain suspension fluid when performing operations related to the hydraulic circuits.

·

Draining suspension fluid decreases suspension fluid pressure.




b.

Tighten the bleeder plug.

Torque:
8.3 N*m (85 kgf*cm, 73 in.*lbf)


Hide 48890 5.DISCONNECT FRONT NO. 1 STABILIZER CONTROL TUBE ASSEMBLY

a.
C301673

Using a union nut wrench, disconnect the 2 flare nuts from the stabilizer control with accumulator housing to disconnect the front No. 1 stabilizer control tube assembly.


Hide 44327N 6.DISCONNECT REAR NO. 1 STABILIZER CONTROL TUBE ASSEMBLY

a.
C301799

Using a union nut wrench, disconnect the 2 flare nuts from the stabilizer control with accumulator housing.


b.

Remove the 2 bolts and disconnect the rear No. 1 stabilizer control tube assembly.


Hide 48860D 7.REMOVE STABILIZER CONTROL WITH ACCUMULATOR HOUSING ASSEMBLY

a.
C214833

Disconnect the connector, and then detach the clamp from the sensor bracket.


b.

Remove the 3 bolts and stabilizer control with accumulator housing.

NOTICE:

Do not disassemble the stabilizer control with accumulator housing assembly or expose it to an open flame as the accumulator of the stabilizer control with accumulator housing assembly contains gas.