Home › Suspension › SUSPENSION CONTROL › HEIGHT CONTROL COMPRESSOR › 2015.06–2020.08
RM27T0E _53 Suspension _053706 SUSPENSION CONTROL _0260873 HEIGHT CONTROL COMPRESSOR A

SUSPENSION CONTROL  HEIGHT CONTROL COMPRESSOR  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

Before removal, be sure to disable vehicle height control by pressing the height control OFF switch and confirming that the height control OFF indication is displayed on the meter.


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



Hide 2.REMOVE REAR WHEEL LH

Hide 76608 3.REMOVE REAR QUARTER PANEL MUDGUARD SUB-ASSEMBLY LH

Hide 48978 4.REMOVE HEIGHT CONTROL COMPRESSOR COVER

a.

Remove the 3 clips and height control compressor cover.


Hide 52046A 5.REMOVE REAR BUMPER PROTECTOR SUB-ASSEMBLY LH (for 5 Door)

Hide 48925 6.REMOVE HEIGHT CONTROL FILTER

a.

Slide the 2 clips and disconnect the 2 hoses.


b.
C213661

Remove the 2 bolts and height control filter from the height control compressor bracket.


Hide 48982 7.DISCONNECT NO. 2 HEIGHT CONTROL TUBE

a.
C214856

Disconnect the No. 2 height control tube from the No. 2 height control valve (See page Suspension>SUSPENSION CONTROL>SUSPENSION CONTROL SYSTEM (w/ Air Suspension)>PRECAUTION).

HINT:

For the disconnection procedure of the tube (type 2), refer to Precaution of the Suspension Control System section.



Hide 48910B 8.REMOVE HEIGHT CONTROL COMPRESSOR ASSEMBLY

a.
C213660

Disconnect the connector.


b.

Detach the 3 clamps.


c.

Detach the No. 2 height control tube.


d.
C214821

Disconnect the connector.


e.

Detach the clamp.


f.
C213662

Remove the 3 bolts and height control compressor.


g.
C214816

Remove the bolt and height control dryer.


h.

Remove the O-ring.


i.
C214817

Remove the 3 bushes from the height control compressor.


Hide 48911 9.REMOVE HEIGHT CONTROL COMPRESSOR BRACKET

a.
C214814

Remove the 3 bolts and height control compressor bracket.