Home › Suspension › SUSPENSION CONTROL › HEIGHT CONTROL SENSOR
RM27T0E _53 Suspension _053706 SUSPENSION CONTROL _0260876 HEIGHT CONTROL SENSOR G

SUSPENSION CONTROL  HEIGHT CONTROL SENSOR  INSPECTION  


PROCEDURE

Hide 1.INSPECT REAR HEIGHT CONTROL SENSOR

a.

Check the rear height control sensor.

C214173E02
3.459,0.235 3.640,0.395 0.180,0.159 10 *b 3.898,3.775 4.090,3.948 0.192,0.173 10 *d 4.388,1.955 4.576,2.107 0.188,0.152 10 *c 5.09,0.836 5.316,1.029 0.225,0.193 12 *a

Text in Illustration
*a Component without harness connected
(Rear Height Control Sensor)
*b Min. Low
*c Normal *d Max. High
V100135

45°
V100136

45°

i.

Connect 3 dry cell batteries of 1.5 V in series.


ii.

Connect the positive (+) end of the batteries to terminal 1 (SHB) of the height control sensor and the negative (-) end of the batteries to terminal 3 (SHG). While slowly moving the sensor link up and down, measure the voltage between terminal 2 (SHRR) and terminal 3 (SHG).


iii.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
for RHD
Tester Connection Sensor Condition Specified Condition
3 (SHG) - 2 (SHRR) High (45°) 4.4 to 4.6 V
Normal (0°) 2.3 to 2.6 V
Low (-45°) 0.4 to 0.6 V

for LHD
Tester Connection Sensor Condition Specified Condition
3 (SHG) - 2 (SHRL) High (45°) 4.4 to 4.6 V
Normal (0°) 2.3 to 2.6 V
Low (-45°) 0.4 to 0.6 V


NOTICE:

Do not apply higher than 6 V.


If the result is not as specified, replace the height control sensor.