Home › Suspension › SUSPENSION CONTROL › HEIGHT CONTROL SENSOR › 2015.06–2020.08
RM27T0E _53 Suspension _053706 SUSPENSION CONTROL _0260876 HEIGHT CONTROL SENSOR A

SUSPENSION CONTROL  HEIGHT CONTROL SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

Before removal, be sure to disable vehicle height control by pressing the height control OFF switch and confirming that the height control OFF indication is displayed on the meter.


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



Hide 2.REMOVE REAR WHEEL

Hide 89408D 3.REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH

a.
C212872

Disconnect the connector, and then detach the connector.


b.

Detach the clamp.


c.
C212873E02
3.125,2.188 3.125,3.052 3.125,3.052 2.479,3.052 true 2.948,2.229 2.948,3.042 true 2.313,2.958 2.469,3.104 0.156,0.146 10 false *1

Place matchmarks on the link and bracket.

Text in Illustration
*1 Matchmark


d.

Remove the nut and disconnect the sensor link.


e.

Remove the 2 bolts and height control sensor.

NOTICE:

Replace the rear height control sensor sub-assembly with a new one if it is dropped.



Hide 4.REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.