Home › Suspension › SUSPENSION CONTROL › FRONT ACCELERATION SENSOR
RM27T0E _53 Suspension _053706 SUSPENSION CONTROL _0260879 FRONT ACCELERATION SENSOR G

SUSPENSION CONTROL  FRONT ACCELERATION SENSOR  INSPECTION  


PROCEDURE

Hide 89191A 1.INSPECT FRONT ACCELERATION SENSOR

a.
C214175E11
2.49,1.625 2.677,2.083 false 1.906,1.573 1.708,2.021 false 2.313,1.458 2.75,0.917 false 0.094,0.115 0.344,0.323 0.25,0.208 10 false *a 2.656,2.135 3.146,2.333 0.49,0.198 10 false SGFR 1.448,2.042 1.813,2.24 0.365,0.198 10 false SBR 2.833,0.792 3.229,1 0.396,0.208 10 false SGR

Connect 3 dry batteries of 1.5 V in series.


b.

Connect the positive (+) end of the batteries to terminal 3 (SBR) of the acceleration sensor and the negative (-) end of the batteries to terminal 2 (SGR). Then measure the voltage between terminal 1 (SGFR) and terminal 2 (SGR).


c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Sensor Condition Specified Condition
1 (SGFR) - 2 (SGR) Sensor stationary Approx. 2.0 to 2.5 V
Sensor tilted Changes between approx. 0.9 and 2.3 V


Text in Illustration
*a Component without harness connected
(Front Acceleration Sensor)
V100135

Top
V100136

Bottom

HINT:

When the front acceleration sensor is tilted, it may output a different value.


NOTICE:
·

Do not apply higher than 6 V.

·

Do not drop the front acceleration sensor. If it is dropped, replace it with a new one.

·

Never place the front acceleration sensor upside down.



If the result is not as specified, replace the front acceleration sensor.