Home › Suspension › SUSPENSION CONTROL › REAR ACCELERATION SENSOR
RM27T0E _53 Suspension _053706 SUSPENSION CONTROL _0260880 REAR ACCELERATION SENSOR G

SUSPENSION CONTROL  REAR ACCELERATION SENSOR  INSPECTION  


PROCEDURE

Hide 89191A 1.INSPECT REAR ACCELERATION SENSOR

a.
C214175E12
2.51,1.615 2.688,2.083 false 1.99,1.604 1.792,2.052 false 2.313,1.469 2.75,0.938 false 0.146,0.104 0.427,0.365 0.281,0.26 10 false *a 2.74,2.125 3.26,2.323 0.521,0.198 10 false SGRR 1.479,2.094 1.844,2.292 0.365,0.198 10 false SGV 2.833,0.823 3.302,1.031 0.469,0.208 10 false SGND

Connect 3 dry batteries of 1.5 V in series.


b.

Connect the positive (+) end of the batteries to terminal 3 (SGV) of the acceleration sensor and the negative (-) end of the batteries to terminal 2 (SGND). Then measure the voltage between terminal 1 (SGRR) and terminal 2 (SGND).


c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Sensor Condition Specified Condition
1 (SGRR) - 2 (SGND) Sensor stationary Approx. 2.0 to 2.5 V
Sensor tilted Changes between approx. 0.9 and 2.3 V


Text in Illustration
*a Component without harness connected
(Rear Acceleration Sensor)
V100135

Top
V100136

Bottom

HINT:

When the rear acceleration sensor is tilted, it may output a different value.


NOTICE:
·

Do not apply higher than 6 V.

·

Do not drop the rear acceleration sensor. If it is dropped, replace it with a new one.

·

Never place the rear acceleration sensor upside down.



If the result is not as specified, replace the rear acceleration sensor.