89241B
1.INSPECT ABSORBER CONTROL ACTUATOR
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 (FAL+) - 2 (FAL-) | Always | 6.4 to 7.2 Ω |
| 3 (FBL+) - 4 (FBL-) | 6.4 to 7.2 Ω |
| *a | Component without harness connected
(Absorber Control Actuator LH) |
If the result is not as specified, replace the absorber control actuator.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 (FAR+) - 2 (FAR-) | Always | 6.4 to 7.2 Ω |
| 3 (FBR+) - 4 (FBR-) | 6.4 to 7.2 Ω |
| *a | Component without harness connected
(Absorber Control Actuator RH) |
If the result is not as specified, replace the absorber control actuator.