Home › Suspension › SUSPENSION CONTROL › ABSORBER CONTROL ACTUATOR › 2015.06–2020.08
RM27T0E _53 Suspension _053706 SUSPENSION CONTROL _0260881 ABSORBER CONTROL ACTUATOR A

SUSPENSION CONTROL  ABSORBER CONTROL ACTUATOR  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



Hide 2.REMOVE FRONT WHEEL

Hide 89241B 3.REMOVE ABSORBER CONTROL ACTUATOR LH

a.
C213631

Detach the 3 clamps, and then disconnect the connector.


b.

Using a hexagon wrench (4 mm), remove the 2 hexagon socket head cap bolts and absorber control actuator.

NOTICE:

Replace the absorber control actuator with a new one if it is dropped.



Hide 89269A 4.REMOVE SUSPENSION CONTROL BRACKET LH

a.
C115604E01
2.697,1.012 3.131,1.217 0.434,0.205 10 SST 2.697,1.081 2.499,1.081 false 2.499,1.081 2.242,1.778 false

Using SST, remove the nut and bracket.

SST
09961-00950