55936E
1.INSPECT CENTER CLUSTER MODULE SWITCH (ABSORBER CONTROL SWITCH)
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 8 (ECU2) - 24 (E) | COMFORT position | Below 1 Ω |
| Normal position | 10 kΩ or higher | |
| 9 (ECU1) - 24 (E) | SPORT position | Below 1 Ω |
| Normal position | 10 kΩ or higher |
| *a | Component without harness connected
(Absorber Control Switch) |
If the result is not as specified, replace the center cluster module switch (absorber control switch).