DESCRIPTION
System description
In the KDSS (Kinetic Dynamic Suspension System), a cylinder is installed to each of the front and rear stabilizer bars. The front and rear cylinder upper chambers and the front and rear lower chambers are each connected by a pipe. The hydraulic circuit is filled with high-pressure suspension fluid. The ECU controls the stabilizer control solenoid valves according to input signals from sensor.
FUNCTION OF COMPONENTS
| Part Name | Function | |
|---|---|---|
| Stabilizer Control ECU | ·
Closes the stabilizer control valves according to input signals from the sensor to cut the fluid flow to the accumulators. ·
Turns on the KDSS indicator light in the combination meter to inform the driver when an abnormality is detected in the KDSS. When this happens, a DTC is stored. |
|
| Stabilizer Control with Accumulator Housing Assembly | Accumulator Pressure Sensor | Detects the pressure in the hydraulic circuit. |
| Stabilizer Control Solenoid Valve | Cuts the fluid flow to the accumulator. | |
| Speed Sensor (Skid Control ECU) | Detects the wheel speed of each wheel. | |
| Steering Angle Sensor | Detects the steering wheel's steering angle and amount of movement, and then sends signals to the stabilizer control ECU. | |
| Yaw Rate and Acceleration Sensor | Detects vehicle's the yaw rate and acceleration and sends signals to the stabilizer control ECU. | |