Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).
48730
1.TEMPORARILY INSTALL LOWER CONTROL ARM ASSEMBLY LH
Temporarily install the lower control arm assembly with the bolt and nut.
| *a | Front |
| *b | Outer Side |
Install the lower control arm assembly as shown in the illustration.
Temporarily install the lower control arm assembly to the rear axle housing with the nut and bolt.
46430
2.CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY
Connect the No. 3 parking brake cable assembly with the bolt.
3.INSTALL REAR WHEEL
4.STABILIZE SUSPENSION
48730
5.TIGHTEN LOWER CONTROL ARM ASSEMBLY LH
Tighten the 2 bolts.
While holding the nut, turn the bolt.