Refer to DTCs C1401 and C1402 (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM(for Vacuum Brake Booster)>C1401).
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1409
C1410 |
One of the following conditions is met:
1.
When the vehicle is driven in reverse at a speed of 3 km/h (1.8 mph) or more and 3 of the wheel sensors detect the reverse signal, the other sensor detects a high frequency pulse 75 times while the ignition switch is ON. 2.
At a vehicle speed of 10 km/h (6 mph) or more, the vehicle speed sensor output drops by 50% for 5 seconds. 3.
The lowest wheel speed is 10 km/h (6 mph) or more and the difference between the highest and lowest wheel speed values is 2 km/h (1 mph) or less for 15 seconds. 4.
At a vehicle speed of 30 km/h (18 mph) or more, one wheel direction is different from the other 3 wheels for 1 second. 5.
At a vehicle speed of 100 km/h (60 mph), a reverse signal is output for 1 second or more. 6.
At a vehicle speed of 30 km/h (18 mph) or more, the rotation direction of the one of the wheels is not detected normally and the rotation direction of the other 3 wheels is not the same for 1 second. |
Front speed sensor RH/LH |
DTC C1409 is for the front speed sensor RH.
DTC C1410 is for the front speed sensor LH.
Refer to DTCs C1405 and C1406 (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM(for Vacuum Brake Booster)>C1405).
Check the speed sensor signal after replacement (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM(for Vacuum Brake Booster)>TEST MODE PROCEDURE).
Replace the front speed sensor (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>FRONT SPEED SENSOR>REMOVAL).
NEXT