Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL (for Vacuum Brake Booster)
RM27T0E _54 Brake _053713 BRAKE SYSTEM (OTHER) _0260925 BRAKE PEDAL(for Vacuum Brake Booster) G

BRAKE SYSTEM (OTHER)  BRAKE PEDAL(for Vacuum Brake Booster)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 84341 1.INSPECT BRAKE PEDAL LOAD SENSING SWITCH

HINT:
·

Do not remove the brake pedal load sensing switch from the brake pedal lever sub-assembly.

·

When there is a malfunction in the brake pedal load sensing switch, replace the brake pedal lever sub-assembly.

·

The illustration below is for LHD vehicles. Check the brake pedal load sensing switch for RHD vehicles using the same procedure as for LHD vehicles.



a.

Disconnect the brake pedal load sensing switch connector.

C217151E04
6.146,0.469 5.719,0.292 5.719,0.292 5.469,0.292 false 4.188,2 3.948,2.281 3.948,2.281 3.76,2.281 false 1.375,1.24 1.375,1.917 1.375,1.917 1.458,1.917 false 1.375,1.167 1.375,0.375 1.375,0.375 1.469,0.375 false 1.385,2.979 0.948,2.979 true 1.677,3.052 1.677,3.469 true 1.51,0.281 1.729,0.469 0.219,0.188 10 false *a 1.479,1.844 1.667,2.01 0.188,0.167 10 false *b 2.438,1.063 2.583,1.219 0.146,0.156 10 false 1 0.531,1.063 0.688,1.229 0.156,0.167 10 false 2 5.281,0.229 5.479,0.385 0.198,0.156 10 false *1 3.563,2.208 3.75,2.385 0.188,0.177 10 false *2 0.469,2.906 0.958,3.083 0.49,0.177 10 false FSW+ 1.458,3.5 1.948,3.667 0.49,0.167 10 false FSW-

Text in Illustration
*1 Brake Pedal Load Sensing Switch *2 Brake Pedal Support Assembly
*a Brake Pedal Released (ON) *b Brake Pedal Depressed (OFF)


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
2 (FSW+) - 1(FSW-) Brake pedal depressed 0.9 to 1.1 kΩ
Brake pedal released 192 to 234 Ω


If the result is not as specified, replace the brake pedal support assembly (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE PEDAL (for Vacuum Brake Booster)>REMOVAL).