Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
73900
2.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
Remove the lower No. 1 instrument panel airbag assembly (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>KNEE AIRBAG ASSEMBLY>REMOVAL).
47101A
3.REMOVE BRAKE PEDAL RETURN SPRING
47264A
4.REMOVE PUSH ROD PIN
Remove the clip and push rod pin from the brake pedal.
84340
5.REMOVE STOP LIGHT SWITCH ASSEMBLY
Disconnect the stop light switch connector.
Remove the stop light switch assembly (See page Vehicle Exterior>LIGHTING (EXT)>STOP LIGHT SWITCH>REMOVAL).
84341
6.DISCONNECT BRAKE PEDAL LOAD SENSING SWITCH
Disconnect the brake pedal load sensing switch connector.
7.REMOVE BRAKE PEDAL SUPPORT ASSEMBLY
Remove the brake pedal support reinforcement set bolt.
for LHD:
Remove the brake master cylinder sub-assembly (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE MASTER CYLINDER>REMOVAL).
Remove the brake booster assembly (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE BOOSTER>REMOVAL).
for RHD:
Remove the brake actuator assembly (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR>REMOVAL).
Remove the brake master cylinder sub-assembly (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE MASTER CYLINDER>REMOVAL).
Remove the brake booster assembly (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE BOOSTER>REMOVAL).
Remove the 4 nuts and brake pedal support assembly.