Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE REAR WHEEL LH
2.DISCONNECT REAR DISC BRAKE CYLINDER ASSEMBLY LH
Remove the 2 bolts and disconnect the rear disc brake cylinder.
Do not disconnect the flexible hose from the disc brake cylinder.
Do not twist or bend the flexible hose.
Hang the disc brake cylinder with a piece of wire.
42431
3.REMOVE REAR DISC
46550E
4.REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING
Remove the 2 parking brake shoe return tension springs.
46580
5.DISCONNECT NO. 1 PARKING BRAKE SHOE ASSEMBLY LH
Remove the parking brake shoe hold down spring cups and parking brake shoe hold down spring to disconnect the No. 1 parking brake shoe assembly from the backing plate.
47614
6.REMOVE PARKING BRAKE SHOE STRUT LH
Remove the parking brake shoe strut and parking brake shoe strut compression spring.
46590
7.DISCONNECT NO. 2 PARKING BRAKE SHOE ASSEMBLY LH
Remove the parking brake shoe hold down spring cup and parking brake shoe hold down spring to disconnect the No. 2 parking brake shoe assembly from the backing plate.
47406A
8.REMOVE PARKING BRAKE SHOE ADJUSTING SCREW SET
Remove the parking brake shoe adjusting screw set.
46580
9.REMOVE NO. 1 PARKING BRAKE SHOE ASSEMBLY LH
Disconnect the parking brake shoe return tension spring to remove the No. 1 parking brake shoe assembly.
46550A
10.REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING
Remove the parking brake shoe return tension spring from the No. 2 parking brake shoe assembly.
46590
11.REMOVE NO. 2 PARKING BRAKE SHOE ASSEMBLY WITH PARKING BRAKE SHOE LEVER
Using needle-nose pliers, disconnect the No. 3 parking brake cable assembly from the parking brake shoe lever as shown in the illustration.
Be careful not to damage the No. 3 parking brake cable assembly.
47612
12.REMOVE PARKING BRAKE SHOE LEVER LH
Remove the C-washer, shim and parking brake shoe lever from the No. 2 parking brake shoe assembly as shown in the illustration.
47447E
13.REMOVE PARKING BRAKE SHOE HOLD DOWN SPRING PIN
Remove the parking brake shoe hold down spring pin (for front side).
Remove the parking brake shoe hold down spring pin (for rear side).