When using a vise, do not overtighten it.
When installing the parts indicated by arrows, coat them with power steering fluid (See page Steering>POWER ASSIST SYSTEMS>VANE PUMP (for 2TR-FE)>COMPONENTS).
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
16361A
2.REMOVE FAN AND GENERATOR V BELT
44412
3.DISCONNECT RETURN HOSE
Remove the clip and disconnect the hose.
44410
4.DISCONNECT PRESSURE FEED TUBE ASSEMBLY (w/ VSC)
Disconnect the 2 connectors.
Remove the union bolt and disconnect the pressure feed tube from the vane pump.
Remove the gasket from the pressure feed tube.
44410
5.DISCONNECT PRESSURE FEED TUBE ASSEMBLY (w/o VSC)
Remove the union bolt and disconnect the pressure feed tube from the vane pump.
Remove the gasket from the pressure feed tube.
44310
6.REMOVE VANE PUMP ASSEMBLY (w/ VSC)
Remove the 2 bolts and vane pump.
44310
7.REMOVE VANE PUMP ASSEMBLY (w/o VSC)
Disconnect the connector from the power steering oil pressure switch.
Remove the 2 bolts and vane pump.