Home › Steering › POWER ASSIST SYSTEMS › VANE PUMP (for 1KD-FTV) › 2015.06–2020.08
RM27T0E _55 Steering _053717 POWER ASSIST SYSTEMS _0260949 VANE PUMP(for 1KD-FTV) A

POWER ASSIST SYSTEMS  VANE PUMP(for 1KD-FTV)  INSTALLATION  


PROCEDURE

Hide 44310 1.INSTALL VANE PUMP ASSEMBLY

a.

Coat a new O-ring with power steering fluid and install it to the vane pump.


b.

Install the pump with the 2 nuts.

Torque:
39 N*m (398 kgf*cm, 29 ft.*lbf)


Hide 44348A 2.INSTALL NO. 1 OIL RESERVOIR TO PUMP HOSE

a.

Install the oil reservoir to pump hose with the clamp.

HINT:
·

Install the pump side of the hose so that the paint mark faces the front of the vehicle. Align the paint mark on the reservoir tank side of the hose to the tank port rib.

·

Make sure the claws of the clamp on the pump side face the front of the vehicle. Also make sure the claws of the clamp claw on the reservoir tank side face the top of the vehicle.




Hide 44410 3.INSTALL PRESSURE FEED TUBE ASSEMBLY

a.

Install a new gasket to the pressure feed tube.


b.

Connect the pressure feed tube and install the union bolt.

Torque:
50 N*m (510 kgf*cm, 37 ft.*lbf)

HINT:

Make sure the stopper of the pressure feed tube touches the vane pump.



c.

Connect the 2 connectors.


Hide 51405A 5.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 53737B 7.INSTALL FRONT FENDER APRON SEAL LH

a.

Attach the 5 clips install the apron seal.


Hide 53737A 8.INSTALL NO. 1 FRONT FENDER APRON TO FRAME SEAL LH

a.

Attach the 5 clips install the apron seal.


Hide 9.INSTALL FRONT WHEEL LH

Torque:
for steel wheel : 112 N*m (1137 kgf*cm, 82 ft.*lbf)
for aluminum wheel : 103 N*m (1050 kgf*cm, 76 ft.*lbf)

Hide 10.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 11.ADD POWER STEERING FLUID

Hide 13.INSPECT FOR POWER STEERING FLUID LEAK