Home › Steering › POWER ASSIST SYSTEMS › VANE PUMP (for 1KD-FTV) › 2015.06–2020.08
RM27T0E _55 Steering _053717 POWER ASSIST SYSTEMS _0260949 VANE PUMP(for 1KD-FTV) A

POWER ASSIST SYSTEMS  VANE PUMP(for 1KD-FTV)  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·

When using a vise, do not overtighten it.

·

When installing the parts indicated by arrows, coat them with power steering fluid (See page Steering>POWER ASSIST SYSTEMS>VANE PUMP (for 1KD-FTV)>COMPONENTS).



PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



Hide 2.REMOVE FRONT WHEEL RH

Hide 51405A 4.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 51450 5.REMOVE REAR ENGINE UNDER COVER ASSEMBLY

Hide 53737B 6.REMOVE FRONT FENDER APRON SEAL LH

a.

Detach the 5 clips remove the apron seal.


Hide 53737A 7.REMOVE NO. 1 FRONT FENDER APRON TO FRAME SEAL LH

a.

Detach the 5 clips remove the apron seal.


Hide 44410 8.REMOVE PRESSURE FEED TUBE ASSEMBLY

a.
C215466

Disconnect the 2 connectors.


b.
C215467

Remove the union bolt and disconnect the pressure feed tube from the vane pump.


c.

Remove the gasket from the pressure feed tube.


Hide 44348A 9.DISCONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE

a.
C215468

Remove the clamp and disconnect the hose.


Hide 44310 10.REMOVE VANE PUMP ASSEMBLY

a.
U170115

Remove the 2 nuts and vane pump.


b.

Remove the O-ring.