Home › Steering › STEERING COLUMN › STEERING LOCK SYSTEM › 2015.06–2017.08
RM27T0E _55 Steering _053718 STEERING COLUMN _0260954 STEERING LOCK SYSTEM C

STEERING COLUMN  STEERING LOCK SYSTEM  B2788  IG2 Signal Malfunction  


DESCRIPTION

The steering lock ECU determines the on/off status of the engine switch through the IG2 signal circuit.

The steering lock ECU does not lock the steering when it receives the IG2 relay on signal. This prevents the steering from being locked while the vehicle is moving.

The diagnosis information of the steering lock ECU is transmitted to the intelligent tester via the certification ECU as the steering lock ECU is not connected to the CAN communication system.

DTC Code Detection Condition Trouble Area
B2788 The IG2 input to the steering lock ECU does not match the LIN communication input.
·

IGN fuse

·

Steering lock actuator assembly (steering lock ECU)

·

Power management control ECU

·

Harness or connector



WIRING DIAGRAM

C198342E08
3.484,1.176 3.770,1.323 0.286,0.147 10 IGN 4.353,1.933 4.490,2.080 0.137,0.147 10 1 4.339,0.924 4.476,1.071 0.137,0.147 10 6 4.576,1.036 4.888,1.182 0.313,0.147 10 IG2 4.576,2.026 4.972,2.172 0.396,0.147 10 GND 1.497,1.016 2.538,1.163 1.041,0.147 10 from IG2 Relay 4.216,2.799 6.316,3.141 2.100,0.341 10 Steering Lock Actuator Assembly (Steering Lock ECU) 5.457,1.459 6.779,1.671 1.323,0.211 10 Steering Lock Motor 0.152,2.799 2.447,2.955 2.295,0.156 10 Power Management Control ECU 0.786,3.466 2.470,3.608 1.684,0.142 10 LIN Communication Line 0.152,2.662 0.532,2.860 0.380,0.199 10 G51 4.217,2.662 4.597,2.860 0.380,0.199 10 G35

CAUTION / NOTICE / HINT

HINT:

When the engine switch is off, the main body ECU may occasionally go into a non-active state called sleep mode. Therefore, before proceeding with the inspection, it is necessary to perform the following steps to wake up the ECU:

With the engine switch off, open the driver door. Then (with the engine switch still off) open and close any door several times at 1.5 second intervals.


NOTICE:
·

If the steering lock actuator assembly (steering lock ECU) is replaced, with the engine switch off and the shift lever in P (for Automatic Transmission), open and close the driver side door to record the current lock position into the steering lock ECU. If this is not performed, the engine may not start.

·

When replacing the steering lock ECU, registration must be performed. Refer to the Service Bulletin for the registration procedure.

·

Inspect the fuses for circuits related to this system before performing the following inspection procedure.



PROCEDURE

1.CHECK STEERING LOCK ACTUATOR ASSEMBLY (STEERING LOCK ECU)
a.
U169947E01
0.119,0.063 0.443,0.312 0.324,0.250 10 *a 0.336,1.912 0.696,2.063 0.360,0.151 10 GND 0.234,1.013 0.539,1.164 0.305,0.151 10 G35 0.78,1.997 0.901,1.997 0.901,1.997 1.128,1.226 false

Disconnect the G35 steering lock ECU connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G35-1 (GND) - Body ground Always Below 1 Ω


Text in Illustration
*a Front view of wire harness connector
(to Steering Lock ECU)


c.
U169920E01
0.52,1.612 0.884,1.798 0.364,0.186 10 IG2 0.097,0 0.489,0.225 0.392,0.225 10 *a 2.79,1.616 3.154,1.802 0.364,0.186 10 GND 0.837,1.7 1.007,1.7 1.007,1.7 1.397,1.145 false 2.294,1.134 2.507,1.69 2.507,1.69 2.726,1.69 false 0.227,0.656 0.545,0.806 0.317,0.151 10 G35

Reconnect the G35 steering lock ECU connector.


d.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
G35-6 (IG2) - G35-1 (GND) Engine switch on (IG) 11 to 14 V
G35-6 (IG2) - G35-1 (GND) Engine switch off Below 1 V


Text in Illustration
*a Component with harness connected
(Steering Lock ECU)

Result
Result Proceed to
NG A
OK for Manual Tilt and Manual Telescopic Steering Column B
for Power Tilt and Power Telescopic Steering Column C



A

CHECK FOR SHORT IN ALL HARNESSES, CONNECTORS AND COMPONENTS CONNECTED TO IG2 FUSE

B

C