Home › Steering › STEERING COLUMN › POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM › 2015.06–2017.08
RM27T0E _55 Steering _053718 STEERING COLUMN _0260955 POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM C

STEERING COLUMN  POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM  B2621  Communication Interruption  


DESCRIPTION

The multiplex tilt and telescopic ECU forms a network with the ECUs of other systems through the CAN communication bus. Each ECU informs the other ECUs that it is connected to the network by outputting a specified signal (periodic signal) to the CAN communication bus on a regular schedule. The multiplex tilt and telescopic ECU detects the connection of each ECU based on the signal.

DTC Code Detection Condition Trouble Area
B2621 The periodic signal from a specified ECU has stopped.
·

CAN communication system

·

Multiplex tilt and telescopic ECU



PROCEDURE

1.CHECK DTC (CAN COMMUNICATION SYSTEM)
a.

Check for DTCs of the CAN communication system.

for LHD with Entry and Start System:

Refer to the following procedures (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD with Entry and Start System)>DIAGNOSIS SYSTEM).

for RHD with Entry and Start System:

Refer to the following procedures (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for RHD with Entry and Start System)>DIAGNOSIS SYSTEM).

Result
Result Proceed to
DTC is not output. A
DTC is output. for LHD with Entry and Start System B
for RHD with Entry and Start System C



A

REPLACE MULTIPLEX TILT AND TELESCOPIC ECU

B

C