Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing the steering wheel (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
45187
2.REMOVE NO. 3 STEERING WHEEL LOWER COVER
45186
3.REMOVE NO. 2 STEERING WHEEL LOWER COVER
45130
4.REMOVE STEERING PAD ASSEMBLY
55910E
5.REMOVE STEERING WHEEL HEATER CONTROL ASSEMBLY
Disconnect the 2 connectors and connector clamp.
Remove the 2 screws and steering wheel heater control assembly.