Home › Audio / Visual / Telematics › AUDIO / VIDEO › REAR SEAT ENTERTAINMENT SYSTEM › 2015.06–2020.08
RM27T0E _56 Audio / Visual / Telematics _053720 AUDIO / VIDEO _0260968 REAR SEAT ENTERTAINMENT SYSTEM J

AUDIO / VIDEO  REAR SEAT ENTERTAINMENT SYSTEM  Sound Signal Circuit between Video Terminal and Television Display  


DESCRIPTION

This is the sound signal circuit from the video (video adapter) terminal to the television display assembly.

WIRING DIAGRAM

E284347E01
6.135,0.282 6.556,0.460 0.422,0.178 10 ADPI 5.873,0.192 6.062,0.370 0.190,0.178 10 18 6.135,0.723 6.556,0.900 0.422,0.178 10 SNG3 5.873,0.632 6.062,0.810 0.190,0.178 10 19 6.135,1.605 6.556,1.783 0.422,0.178 10 R+ 5.873,1.515 6.062,1.693 0.190,0.178 10 22 5.792,2.355 6.214,2.533 0.422,0.178 10 W14 5.792,2.523 7.074,2.893 1.282,0.371 10 Television Display Assembly 0.162,2.371 0.662,2.549 0.499,0.178 10 T1 0.162,2.539 1.572,2.909 1.410,0.371 10 Video (Video Adapter) Terminal 0.64,0.282 1.066,0.460 0.426,0.178 10 ADPG 0.784,0.723 1.067,0.900 0.283,0.178 10 VA- 0.668,1.605 1.066,1.783 0.398,0.178 10 VAR+ 1.188,0.192 1.312,0.370 0.123,0.178 10 8 1.188,0.632 1.312,0.810 0.123,0.178 10 3 6.135,2.044 6.556,2.222 0.422,0.178 10 SNG6 5.873,1.954 6.062,2.131 0.190,0.178 10 21 0.822,2.044 1.067,2.222 0.246,0.178 10 SG 1.188,1.954 1.312,2.131 0.123,0.178 10 7 1.188,1.515 1.312,1.693 0.123,0.178 10 1 4.26,2.208 4.911,2.385 0.651,0.178 10 Shielded 2.332,2.208 2.983,2.385 0.651,0.178 10 Shielded 6.135,1.163 6.556,1.341 0.422,0.178 10 L+ 0.669,1.163 1.066,1.341 0.397,0.178 10 VAL+ 5.873,1.073 6.062,1.251 0.190,0.178 10 20 1.188,1.073 1.312,1.251 0.123,0.178 10 2

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (TELEVISION DISPLAY ASSEMBLY - VIDEO [VIDEO ADAPTER] TERMINAL)
a.

Disconnect the W14 television display assembly connector.


b.

Disconnect the T1 video (video adapter) terminal connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
W14-18 (ADPI) - T1-8 (ADPG) Always Below 1 Ω
W14-19 (SGN3) - T1-3 (VA-) Always Below 1 Ω
W14-20 (L+) - T1-2 (VAL+) Always Below 1 Ω
W14-21 (SNG6) - T1-7 (SG) Always Below 1 Ω
W14-22 (R+) - T1-1 (VAR+) Always Below 1 Ω
W14-18 (ADPI) - Body ground Always 10 kΩ or higher
W14-19 (SGN3) - Body ground Always 10 kΩ or higher
W14-20 (L+) - Body ground Always 10 kΩ or higher
W14-21 (SNG6) - Body ground Always 10 kΩ or higher
W14-22 (R+) - Body ground Always 10 kΩ or higher




OK

2.CHECK VIDEO (VIDEO ADAPTER) TERMINAL

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK VIDEO (VIDEO ADAPTER) TERMINAL
a.
U149203E01
0.205,2.172 0.489,2.336 0.284,0.163 10 T1 1.411,1.69 1.812,1.855 0.401,0.165 10 VAL+ 1.411,2.194 1.849,2.359 0.438,0.165 10 VAR+ 0.888,2.25 1.154,1.793 1.154,1.793 1.388,1.793 false 1.015,2.285 1.388,2.285 false 0.053,3.218 0.388,3.414 0.335,0.196 0.116,0.047 2.424,0.453 2.309,0.406 10 *a

Remove the video (video adapter) terminal connector still connected (See page Audio / Visual / Telematics>AUDIO / VIDEO>STEREO JACK ADAPTER ASSEMBLY>REMOVAL).


b.

Using an oscilloscope, check the waveform between each terminal and the body ground according to the conditions as shown in the table below.

Standard:
Tester Connection Condition Specified Condition
T1-1 (VAR+) - Body ground External device playing, sound being produced Waveform synchronized with sound is output
T1-2 (VAL+) - Body ground


Text in Illustration
*a Component with harness connected
(Video [Video Adapter] Terminal)



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG