1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
84010A
3.REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY
55449C
4.REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION
55448A
5.REMOVE NO. 1 INSTRUMENT PANEL FINISH PANEL CUSHION
55436A
6.REMOVE INSTRUMENT PANEL FINISH PANEL END LH
55435A
7.REMOVE INSTRUMENT PANEL FINISH PANEL END RH
58831A
8.REMOVE FRONT CONSOLE UPPER PANEL GARNISH
33504F
9.REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
10.REMOVE CONSOLE PANEL SUB-ASSEMBLY (for Automatic Transmission)
11.REMOVE CONSOLE PANEL SUB-ASSEMBLY (for Manual Transmission)
86190C
12.REMOVE NO. 1 STEREO JACK ADAPTER ASSEMBLY (for Automatic Transmission)
Detach the 2 claws and remove the stereo jack adapter.
86190C
13.REMOVE NO. 1 STEREO JACK ADAPTER ASSEMBLY (for Manual Transmission)
Detach the 2 claws and remove the stereo jack adapter.
58903A
14.REMOVE REAR CONSOLE END PANEL SUB-ASSEMBLY
86191A
15.REMOVE VIDEO (VIDEO ADAPTER) TERMINAL
Disconnect the connector.
Detach the clamp and 4 claws and remove the video terminal.
86192B
16.REMOVE HEADPHONE TERMINAL
Disconnect the 2 connectors.
Detach the 4 claws and 2 clamps and remove the 2 headphone terminals.