Home › Audio / Visual / Telematics › AUDIO / VIDEO › REAR SEAT ENTERTAINMENT SYSTEM › 2015.06–2020.08
RM27T0E _56 Audio / Visual / Telematics _053720 AUDIO / VIDEO _0260968 REAR SEAT ENTERTAINMENT SYSTEM J

AUDIO / VIDEO  REAR SEAT ENTERTAINMENT SYSTEM  Display Signal Circuit between Video Terminal and Television Display  


DESCRIPTION

This is the display signal from the video (video adapter) terminal to the television display assembly.

WIRING DIAGRAM

E284349E01
6.135,0.813 6.556,0.991 0.422,0.178 10 ADPI 5.875,0.723 6.058,0.901 0.183,0.178 10 18 6.135,1.696 6.556,1.874 0.422,0.178 10 VG 5.875,1.606 6.058,1.783 0.183,0.178 10 25 5.792,2.446 6.214,2.624 0.422,0.178 10 W14 5.792,2.614 7.074,2.984 1.282,0.371 10 Television Display Assembly 0.083,2.462 0.582,2.640 0.499,0.178 10 T1 0.083,2.63 1.510,3.000 1.427,0.371 10 Video (VIdeo Adapter) Terminal 0.644,0.813 1.066,0.991 0.422,0.178 10 ADPG 0.802,1.696 1.067,1.874 0.265,0.178 10 VV- 1.188,0.723 1.312,0.901 0.123,0.178 10 8 6.135,2.135 6.556,2.313 0.422,0.178 10 SGN5 5.875,2.044 6.058,2.222 0.183,0.178 10 23 1.188,1.606 1.312,1.783 0.123,0.178 10 6 4.26,2.298 4.911,2.476 0.651,0.178 10 Shielded 2.332,2.298 2.983,2.476 0.651,0.178 10 Shielded 3.227,2.298 3.878,2.476 0.651,0.178 10 Shielded 6.135,1.254 6.556,1.432 0.422,0.178 10 VD 0.761,1.254 1.067,1.432 0.306,0.178 10 VV+ 5.875,1.163 6.058,1.341 0.183,0.178 10 24 1.188,1.163 1.312,1.341 0.123,0.178 10 5

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (TELEVISION DISPLAY ASSEMBLY - VIDEO [VIDEO ADAPTER] TERMINAL)
a.

Disconnect the W14 television display assembly connector.


b.

Disconnect the T1 video (video adapter) terminal connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
W14-18 (ADPI) - T1-8 (ADPG) Always Below 1 Ω
W14-24 (VD+) - T1-5 (VV+) Always Below 1 Ω
W14-25 (VG) - T1-6 (VV-) Always Below 1 Ω
W14-23 (SGN5) - Body ground Always 10 kΩ or higher
W14-18 (ADPI) - Body ground Always 10 kΩ or higher
W14-24 (VD+) - Body ground Always 10 kΩ or higher
W14-25 (VG) - Body ground Always 10 kΩ or higher




OK

2.CHECK VIDEO (VIDEO ADAPTER) TERMINAL

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK VIDEO (VIDEO ADAPTER) TERMINAL
a.
U149204E03
1.063,1.958 1.281,2.26 1.281,2.26 1.417,2.26 true 1.406,1.677 1.708,1.854 0.302,0.177 10 false T1 1.479,2.167 1.844,2.344 0.365,0.177 10 false VV+ 0.135,3.479 0.458,3.656 0.323,0.177 10 false GND 0.094,0.073 0.354,0.448 0.26,0.375 10 false *a

Remove the video (video adapter) terminal connector still connected (See page Audio / Visual / Telematics>AUDIO / VIDEO>STEREO JACK ADAPTER ASSEMBLY>REMOVAL).


b.

Using an oscilloscope, check the waveform.

Measurement Condition
Item Content
Terminal No. (Symbol) T1-5 (VV+) - Body ground
Tool Setting 0.2 V/DIV., 0.2 μs./DIV.
Condition External device playing, VTR displayed

OK:

Waveform is as shown in the illustration.


Text in Illustration
*a Component with harness connected
(Video [Video Adapter] Terminal)



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG