Each audio system component connected to the AVC-LAN (communication bus) transfers switch signals using the audio visual communication local area network.
If a short to +B or short to ground occurs in the AVC-LAN, the audio system will not function normally because communication is not possible.
The radio and display receiver assembly is the master unit.
When replacing the radio and display receiver assembly, it is necessary to perform the vehicle contract setting for Connected Services (w/ Connected Services Function).
Remove the radio and display receiver assembly (See page Audio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER (for Radio and Display Type)>REMOVAL).
| *A | w/ Rear Seat Entertainment System | *B | w/ Side Monitor System |
| *a | Component without harness connected
(Radio and Display Receiver Assembly) |
- | - |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 7 (TX1+) - 8 (TX1-) | Always | 60 to 80 Ω |
| 9 (TX+) - 10 (TX-)*1 | Always | 60 to 80 Ω |
| 7 (TX3+) - 8 (TX3-)*2 | Always | 60 to 80 Ω |
*1: w/ Rear Seat Entertainment System
*2: w/ Side Monitor System
OK
NG
(See pageAudio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER (for Radio and Display Type)>REMOVAL)
*1: w/ Rear Seat Entertainment System
*2: w/ Side Monitor System
Disconnect the H50, H51 and H52 radio and display receiver assembly connectors.
Disconnect the H63 stereo component amplifier assembly connector.
Disconnect the W14 television display assembly connector*1.
Disconnect the I6 parking assist ECU connector*2.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H50-7 (TX3+) - I6-11 (TX+)*2 | Always | Below 1 Ω |
| H50-8 (TX3-) - I6-10 (TX-)*2 | Always | Below 1 Ω |
| H51-7 (TX1+) - H63-8 (TX+) | Always | Below 1 Ω |
| H51-8 (TX1-) - H63-7 (TX-) | Always | Below 1 Ω |
| H52-9 (TX+) - W14-3 (TX1+)*1 | Always | Below 1 Ω |
| H52-10 (TX-) - W14-4 (TX1-)*1 | Always | Below 1 Ω |
| H50-7 (TX3+) - Body ground*2 | Always | 10 kΩ or higher |
| H50-8 (TX3-) - Body ground*2 | Always | 10 kΩ or higher |
| H51-7 (TX1+) - Body ground | Always | 10 kΩ or higher |
| H51-8 (TX1-) - Body ground | Always | 10 kΩ or higher |
| H52-9 (TX+) - Body ground)*1 | Always | 10 kΩ or higher |
| H52-10 (TX-) - Body ground*1 | Always | 10 kΩ or higher |
OK
NG
Disconnect and reconnect each slave unit one by one until the master unit returns to normal operation.
Check all slave units.
When disconnecting a slave unit causes the master unit to return to normal operation, this indicates that the slave unit is malfunctioning. Replace the malfunctioning slave unit.
Master unit returns to normal operation.
OK
NG
(See pageAudio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER (for Radio and Display Type)>REMOVAL)