Home › Audio / Visual / Telematics › AUDIO / VIDEO › RADIO RECEIVER (for Radio and Display Type) › 2015.06–2017.08
RM27T0E _56 Audio / Visual / Telematics _053720 AUDIO / VIDEO _0260970 RADIO RECEIVER(for Radio and Display Type) A

AUDIO / VIDEO  RADIO RECEIVER(for Radio and Display Type)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 84010A 3.REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY

Hide 86140A 4.REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY

a.
B358810

Remove the 4 bolts.


b.
B358814

Pull the radio and display receiver assembly to detach the 7 clips on the backside of the radio and display receiver assembly.


c.

Disconnect each connector and remove the radio and display receiver assembly.


Hide 84330 5.REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY

Hide 86841 7.REMOVE NAVIGATION ECU (w/ Navigation System)

Hide 86211J 8.REMOVE NO. 1 RADIO RECEIVER BRACKET

a.
B358804

Remove the 3 screws and No. 1 radio receiver bracket.


Hide 86212C 9.REMOVE NO. 2 RADIO RECEIVER BRACKET

a.
B358805

Remove the 3 screws and No. 2 radio receiver bracket.


Hide 55670 10.REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY