Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
69298C
3.REMOVE NO. 2 DOOR INSIDE HANDLE BEZEL LH
74611C
4.REMOVE ASSIST GRIP COVER LH
67604
5.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY
68174A
6.REMOVE REAR DOOR INNER GLASS WEATHERSTRIP LH
86160C
7.REMOVE REAR SPEAKER SET
Disconnect the connector.
Remove the 3 screws.
Detach the 2 claws and remove the rear speaker set.
Do not touch the cone of the speaker.
86160Y
8.REMOVE REAR NO. 2 SPEAKER ASSEMBLY (for 14 Speakers)
Remove the 2 screws and No. 2 speaker.
Do not touch the cone of the speaker.