Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
74616C
3.REMOVE FRONT NO. 1 ASSIST GRIP PLUG LH
74611F
4.REMOVE NO. 1 ASSIST GRIP
62212
5.REMOVE FRONT PILLAR GARNISH LH
86160J
6.REMOVE FRONT NO. 3 SPEAKER ASSEMBLY
Disconnect the connector.
Detach the clip and claw and remove the front No. 3 speaker.