Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
55401E
3.REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
55843A
4.REMOVE NO. 1 HEATER TO REGISTER DUCT
55844
5.REMOVE NO. 2 HEATER TO REGISTER DUCT
55971C
6.REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT
55972C
7.REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT
55950G
8.REMOVE DEFROSTER NOZZLE ASSEMBLY
86860
9.REMOVE NAVIGATION ANTENNA ASSEMBLY
Detach the 2 clamps.
Remove the 2 screws and navigation antenna assembly.