Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION ECU › 2015.06–2017.08
RM27T0E _56 Audio / Visual / Telematics _053721 NAVIGATION / MULTI INFO DISPLAY _0260990 NAVIGATION ECU A

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION ECU  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 84010A 3.REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY

Hide 86842 5.REMOVE NO. 1 NAVIGATION WIRE

a.
B358806

Disconnect each connector and remove the No. 1 navigation wire.


Hide 86841 6.REMOVE NAVIGATION ECU

a.
B358807

Disconnect the connector.


b.
B358803

Detach the clamp.


c.
B358887

Remove the 4 bolts.


d.
B359356

Remove the navigation ECU as shown in the illustration.


Hide 86705B 7.REMOVE TELEPHONE ANTENNA CORD SUB-ASSEMBLY

a.
B358808

Disconnect the connector and remove the telephone antenna cord sub-assembly.