These DTCs are stored when a malfunction occurs in the navigation receiver assembly.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B1550 | Digital radio tuner has a malfunction | Navigation receiver assembly |
| B15A0 | When either of the conditions below is met:
·
Bus malfunction ·
EEPROM error ·
DSP error |
|
| B15AD | When one of the conditions below is met:
·
Short to ground or +B, or open occurs in gyro signal circuit ·
Gyro sensor malfunction ·
GPS receiver malfunction |
|
| B15B0 | Picture circuit (TFT unit) malfunction | |
| B15B3 | When one of the conditions below is met:
·
AM tuner PLL is unlocked ·
FM tuner PLL is unlocked ·
Tuner malfunction |
|
| B15B4 | When one of the conditions below is met:
·
Mechanical communication error ·
Load/Eject malfunction ·
Read malfunction ·
Mechanical malfunction |
|
| B15B5 | When one of the conditions below is met:
·
Mechanical communication error ·
Load/Eject malfunction ·
Read malfunction ·
Mechanical malfunction |
|
| B15B7 | "Bluetooth" module malfunction |
When replacing the navigation receiver assembly, it is necessary to perform the vehicle contract setting for Connected Services (w/ Connected Services Function).
Check for DTCs (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM (for Navigation Receiver Type)>DTC CHECK / CLEAR).
No DTCs are output.
OK
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
NG