Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for Radio and Display Type) › 2015.06–2020.08
RM27T0E _56 Audio / Visual / Telematics _053721 NAVIGATION / MULTI INFO DISPLAY _0260992 NAVIGATION SYSTEM(for Radio and Display Type) C

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for Radio and Display Type)  B158F  AV Signal Stoppage (Low Battery Voltage)  


DESCRIPTION

This DTC is stored when a video or audio signal is interrupted due to battery voltage input to the radio and display receiver assembly dropping temporarily.

DTC Code DTC Detection Condition Trouble Area
B158F A video or audio signal is interrupted when the battery voltage drops.
·

Radio and display receiver assembly

·

Harness or connector



WIRING DIAGRAM

E280930E07
0.838,0.976 1.684,1.183 0.846,0.207 10 from Battery 3.155,1.163 4.715,1.347 1.560,0.184 10 RAD NO. 1 5.074,0.892 5.198,1.076 0.123,0.184 10 4 5.252,0.99 5.782,1.169 0.531,0.179 10 +B1 5.122,1.901 5.537,2.061 0.415,0.161 10 H49 5.122,2.05 6.412,2.387 1.290,0.336 10 Radio and Display Receiver Assembly

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK VEHICLE SIGNAL (OPERATION CHECK)
a.
E268487

Enter the "Vehicle Signal Check Mode" screen. [Refer to Check Vehicle Signal in Operation Check (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM (for Radio and Display Type)>OPERATION CHECK)]


b.

Check that the battery voltage.

Standard voltage:

11 to 14 V


HINT:

This display is updated once per second. As a result, it is normal for the display to lag behind the actual switch operation.




OK

2.CHECK FOR DTC

NG

3.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY POWER SOURCE)
3.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY POWER SOURCE)
a.
U170690E01
1.538,0.333 1.919,0.517 0.381,0.184 10 H49 2.825,0.475 3.138,0.659 0.312,0.184 10 +B1 0.101,0.079 0.413,0.263 0.312,0.184 10 *a 2.304,0.949 2.55,0.563 2.55,0.563 2.816,0.563 false

Disconnect the radio and display receiver assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
H49-4 (+B1) - Body ground Always 11 to 14 V


Text in Illustration
*a Front view of wire harness connector
(to Radio and Display Receiver Assembly)



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR