This DTC is stored when there is an open or short circuit in the communication line between the front sensors and ECU, or when there is a malfunction in a front sensor.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1AEC | An open or short circuit in the communication line between the front sensors and ECU or a malfunction in a front sensor during initialization mode after the engine switch is turned on (IG). | ·
Front ultrasonic sensor circuit ·
Clearance warning ECU |
Check for DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM (w/ Multi-display)>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| No DTC is output | A |
| DTC C1AEC is output | B |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B
Disconnect the G154 clearance warning ECU connector.
Disconnect the B7 No. 1 ultrasonic sensor (front corner sensor LH) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G154-21 (BOF) - B7-1 (BI) | Always | Below 1 Ω |
| G154-9 (SOF) - B7-3 (SI) | Always | Below 1 Ω |
| G154-19 (E1) - B7-5 (EI) | Always | Below 1 Ω |
| G154-21 (BOF) - Body ground | Always | 10 kΩ or higher |
| G154-9 (SOF) - Body ground | Always | 10 kΩ or higher |
| G154-19 (E1) - Body ground | Always | 10 kΩ or higher |
OK
NG
Disconnect the B7 No. 1 ultrasonic sensor (front corner sensor LH) connector.
Disconnect the B8 No. 1 ultrasonic sensor (front center sensor LH) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| B7-2 (BO) - B8-1 (BI) | Always | Below 1 Ω |
| B7-4 (SO) - B8-3 (SI) | Always | Below 1 Ω |
| B7-6 (EO) - B8-5 (EI) | Always | Below 1 Ω |
| B7-2 (BO) - Body ground | Always | 10 kΩ or higher |
| B7-4 (SO) - Body ground | Always | 10 kΩ or higher |
| B7-6 (EO) - Body ground | Always | 10 kΩ or higher |
OK
NG
Disconnect the B8 No. 1 ultrasonic sensor (front center sensor LH) connector.
Disconnect the B9 No. 1 ultrasonic sensor (front center sensor RH) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| B8-2 (BO) - B9-1 (BI) | Always | Below 1 Ω |
| B8-4 (SO) - B9-3 (SI) | Always | Below 1 Ω |
| B8-6 (EO) - B9-5 (EI) | Always | Below 1 Ω |
| B8-2 (BO) - Body ground | Always | 10 kΩ or higher |
| B8-4 (SO) - Body ground | Always | 10 kΩ or higher |
| B8-6 (EO) - Body ground | Always | 10 kΩ or higher |
OK
NG
Disconnect the B9 No. 1 ultrasonic sensor (front center sensor RH) connector.
Disconnect the B10 No. 1 ultrasonic sensor (front corner sensor RH) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| B9-2 (BO) - B10-1 (BI) | Always | Below 1 Ω |
| B9-4 (SO) - B10-3 (SI) | Always | Below 1 Ω |
| B9-6 (EO) - B10-5 (EI) | Always | Below 1 Ω |
| B9-2 (BO) - Body ground | Always | 10 kΩ or higher |
| B9-4 (SO) - Body ground | Always | 10 kΩ or higher |
| B9-6 (EO) - Body ground | Always | 10 kΩ or higher |
OK
NG
Remove the No. 1 ultrasonic sensor (front corner sensor LH) (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR(for Front)>REMOVAL).
Inspect the No. 1 ultrasonic sensor (front corner sensor LH) (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR(for Front)>INSPECTION).
OK
NG
Remove the No. 1 ultrasonic sensor (front center sensor LH) (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR(for Front)>REMOVAL).
Inspect the No. 1 ultrasonic sensor (front center sensor LH) (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR(for Front)>INSPECTION).
OK
NG
Remove the No. 1 ultrasonic sensor (front center sensor RH) (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR(for Front)>REMOVAL).
Inspect the No. 1 ultrasonic sensor (front center sensor RH) (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR(for Front)>INSPECTION).
OK
NG
Replace the No. 1 ultrasonic sensor (front corner sensor RH) with a normally functioning sensor (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR(for Front)>REMOVAL).
NEXT
Check for DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM (w/ Multi-display)>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| No DTC is output | A |
| DTC C1AEC is output | B |
A
B
Replace the No. 1 ultrasonic sensor (front center sensor LH) with a normally functioning sensor (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR(for Front)>REMOVAL).
All of the sensors are interchangeable. To confirm whether a sensor is functioning normally, switch it with a known good sensor from the other end of the vehicle.
NEXT
Check for DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM (w/ Multi-display)>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| No DTC is output | A |
| DTC C1AEC is output | B |
A
B
Replace the No. 1 ultrasonic sensor (front center sensor RH) with a normally functioning sensor (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR(for Front)>REMOVAL).
All of the sensors are interchangeable. To confirm whether a sensor is functioning normally, switch it with a known good sensor from the other end of the vehicle.
NEXT
Check for DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM (w/ Multi-display)>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| No DTC is output | A |
| DTC C1AEC is output | B |
A
B
Replace the No. 1 ultrasonic sensor (front corner sensor LH) with a normally functioning sensor (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR(for Front)>REMOVAL).
All of the sensors are interchangeable. To confirm whether a sensor is functioning normally, switch it with a known good sensor from the other end of the vehicle.
NEXT
Check for DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM (w/ Multi-display)>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| No DTC is output | A |
| DTC C1AEC is output (for LHD) | B |
| DTC C1AEC is output (for RHD) | C |
A
B
(See pageAudio / Visual / Telematics>PARK ASSIST / MONITORING>CLEARANCE WARNING ECU (for LHD)>REMOVAL)
C
(See pageAudio / Visual / Telematics>PARK ASSIST / MONITORING>CLEARANCE WARNING ECU (for RHD)>REMOVAL)