These DTCs are stored if there is a malfunction in the CAN communication system connected to the blind spot monitor sensor.
If CAN communication system DTCs are stored, they may also be stored for other systems.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| U0100 | Lost communication with ECM | CAN communication system |
| U0126 | Lost communication with spiral cable sub-assembly | |
| U0129 | Lost communication with skid control ECU | |
| U0142 | Lost communication with main body ECU (multiplex network body ECU) |
When checking for DTCs, make sure that the blind spot monitor main switch assembly (multi-function switch) is on.
Clear the DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>DTC CHECK / CLEAR).
Check for DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| OK (for LHD with Entry and Start System) | A |
| OK (for LHD without Entry and Start System) | B |
| OK (for RHD with Entry and Start System) | C |
| OK (for RHD without Entry and Start System) | D |
| NG | E |
If CAN communication system DTCs are stored, they may also be stored for other systems.
If the CAN communication system has been inspected and repaired, the DTCs will not be output when rechecking for DTCs.
If these DTCs are output frequently, duplicate the conditions that cause the problem symptoms and perform the inspection again, even though the DTC was not output when rechecking for DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>DTC CHECK / CLEAR).
A
B
C
D
E
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)