This DTC is stored when a beam axis inspection has not been performed for the blind spot monitor sensor LH.
This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that beam axis inspection is performed. Completing the beam axis inspection after replacing a blind spot monitor sensor prevents this DTC from being output.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1ABB | A beam axis inspection has not been performed. | Blind spot monitor sensor LH |
Change the blind spot monitor sensor LH to Test Mode using the GTS.
Refer to Blind Spot Monitor Beam Axis Inspection (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>OPERATION CHECK).
NEXT