These DTCs are stored if there is a malfunction in the CAN communication system connected to the parking assist ECU.
If CAN communication system DTCs are stored, they may also be stored in other systems.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| U0073 | Control module communication bus off | CAN communication system |
| U0100 | Lost communication with ECM | |
| U0114 | Lost Communication with 4WD Control ECU | |
| U0126 | Lost communication with steering angle sensor | |
| U0129 | Lost communication with skid control ECU (brake actuator assembly) | |
| U0140 | Lost communication with main body ECU |
Check for DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM(w/ Side Monitor System)>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC U0073, U0100, U0114, U0126, U0129 and U0140 are not output | A |
| DTC U0073, U0100, U0114, U0126, U0129 or U0140 is output (for LHD with Entry and Start System) | B |
| DTC U0073, U0100, U0114, U0126, U0129 or U0140 is output (for LHD without Entry and Start System) | C |
| DTC U0073, U0100, U0114, U0126, U0129 or U0140 is output (for RHD with Entry and Start System) | D |
| DTC U0073, U0100, U0114, U0126, U0129 or U0140 is output (for RHD without Entry and Start System) | E |
If CAN communication system DTCs are stored, they may also be stored in other systems.
If the CAN communication system has been inspected and repaired in other systems, the DTCs will not be output when rechecking for DTCs.
If these DTCs are output frequently, duplicate the conditions that cause the problem symptoms and perform the inspection again, even though the DTC was not output when rechecking for DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM(w/ Side Monitor System)>PROBLEM SYMPTOMS TABLE).
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B
C
D
E