This DTC is stored when the rear television camera assembly judges that the back camera initial setting has not been memorized (rear television camera assembly optical axis adjustment (back camera position setting) is incomplete).
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1691 | Back camera initial setting has not been memorized (rear television camera assembly optical axis adjustment (back camera position setting) is incomplete) | ·
Rear television camera assembly optical axis adjustment (back camera position setting) ·
Rear television camera assembly |
If the cable was disconnected from and reconnected to the negative (-) battery terminal, the estimated course lines may not be displayed on the image of the area behind the vehicle. In this case, perform "Correct the Steering Angle Neutral Point" (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM (for Camera built-in ECU)>INITIALIZATION).
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM (for Camera built-in ECU)>CALIBRATION).
Perform the following procedure depending on the memory conditions to register the vehicle information into the rear television camera assembly.
Rear television camera assembly optical axis adjustment (back camera position setting) (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM (for Camera built-in ECU)>CALIBRATION).
NEXT
Check for DTCs and check that no DTCs are output (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM (for Camera built-in ECU)>DTC CHECK / CLEAR).
If DTC C1691 is output, perform the rear television camera assembly optical axis adjustment (back camera position setting) again.
If DTC C1691 is still output after performing the rear television camera assembly optical axis adjustment 3 times, replace the rear television camera assembly.
| Proceed to | Result |
|---|---|
| DTC C1691 is not output | A |
| DTC C1691 is output (w/ Tire Carrier) | B |
| DTC C1691 is output (w/o Tire Carrier) | C |
A
B
C