Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM (for Camera built-in ECU) › 2015.06–2020.08
RM27T0E _56 Audio / Visual / Telematics _053722 PARK ASSIST / MONITORING _0261016 PARKING ASSIST MONITOR SYSTEM(for Camera built-in ECU) C

PARK ASSIST / MONITORING  PARKING ASSIST MONITOR SYSTEM(for Camera built-in ECU)  C1694  Steering Angle Initialization Incomplete  


DESCRIPTION

This DTC is stored when the rear television camera assembly judges that the maximum steering angle has not been memorized (steering angle setting is incomplete).

DTC Code DTC Detection Condition Trouble Area
C1694 Maximum steering angle has not been memorized (steering angle setting is incomplete)
·

Steering angle setting

·

Rear television camera assembly



CAUTION / NOTICE / HINT

NOTICE:
·

If the cable was disconnected from and reconnected to the negative (-) battery terminal, the estimated course lines may not be displayed on the image of the area behind the vehicle. In this case, perform "Correct the Steering Angle Neutral Point" (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM (for Camera built-in ECU)>INITIALIZATION).

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM (for Camera built-in ECU)>CALIBRATION).



PROCEDURE

1.PERFORM CALIBRATION
a.

Perform the following procedure depending on the memory conditions to register the vehicle information into the rear television camera assembly.




NEXT

2.CHECK DTC OUTPUT
2.CHECK DTC OUTPUT

b.

Check for DTCs and check that no DTCs are output (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM (for Camera built-in ECU)>DTC CHECK / CLEAR).

HINT:
·

If DTC C1694 is output, perform the steering angle setting again.


·

If DTC C1694 is still output after performing the steering angle setting 3 times, replace the rear television camera assembly.




Result
Proceed to Result
DTC C1694 is not output A
DTC C1694 is output (w/ Tire Carrier) B
DTC C1694 is output (w/o Tire Carrier) C


A

END

B

C