Home › Power Source / Network › 5L-E (BATTERY / CHARGING) › GENERATOR › 2015.06–2020.08
RM27T0E _57 Power Source / Network _053723 5L-E BATTERY / CHARGING _0261017 GENERATOR A

5L-E BATTERY / CHARGING  GENERATOR  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



Hide 16361A 2.REMOVE FAN AND GENERATOR V BELT

a.

Remove the fan and generator V belt (See page Engine / Hybrid System>5L-E (ENGINE MECHANICAL)>DRIVE BELT>REMOVAL).


Hide 88320 3.DISCONNECT COOLER COMPRESSOR ASSEMBLY

Hide 27020 4.REMOVE GENERATOR ASSEMBLY

a.
A224320

Remove the terminal cap.


b.

Remove the nut and generator wire.


c.

Disconnect the generator connector.


d.
A224321

Disconnect the vacuum pump hose.


e.

Remove the union bolt to disconnect the vacuum pump oil inlet hose and remove the 2 gaskets.


f.

Detach the vacuum pump oil inlet hose from the cord clip.


g.

Disconnect the vacuum pump oil outlet hose.


h.
A224322

Remove the 2 bolts and generator.