| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| U1114 | There is no communication from the driving support switch control ECU. | ·
Power source circuit of driving support switch control ECU ·
Driving support switch control ECU CAN branch wire or connector ·
Driving support switch control ECU |
For vehicles with a multi-function switch.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Operating the engine switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.
Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the CAN main wire and the CAN branch wire.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the airbag system.
After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
NEXT
for Automatic Transmission:
Disconnect the G163 driving support switch control ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| G163-2 (CANP) - G163-3 (CANN) | Engine switch off | 54 to 69 Ω |
| *a | Front view of wire harness connector
(to Driving Support Switch Control ECU) |
for Manual Transmission:
Disconnect the G76 driving support switch control ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| G76-9 (CANP) - G76-10 (CANN) | Engine switch off | 54 to 69 Ω |
| *a | Rear view of wire harness connector
(to Driving Support Switch Control ECU) |
OK
NG
Connect the cable to the negative (-) battery terminal.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
for Automatic Transmission:
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G163-7 (GND) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G163-8 (+B) - Body ground | Always | 11 to 14 V |
| G163-10 (IG) - Body ground | Engine switch on (IG) | 11 to 14 V |
| *a | Front view of wire harness connector
(to Driving Support Switch Control ECU) |
for Manual Transmission:
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G76-16 (GND) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G76-6 (+B) - Body ground | Always | 11 to 14 V |
| G76-7 (IG) - Body ground | Engine switch on (IG) | 11 to 14 V |
| *a | Rear view of wire harness connector
(to Driving Support Switch Control ECU) |
OK
NG