Home › Steering › STEERING COLUMN › DRIVING SUPPORT SWITCH CONTROL ECU › 2015.06–2017.08
RM27T0E _55 Steering _053718 STEERING COLUMN _0260962 DRIVING SUPPORT SWITCH CONTROL ECU A

STEERING COLUMN  DRIVING SUPPORT SWITCH CONTROL ECU  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



Hide 55607 6.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 859A1 8.REMOVE DRIVING SUPPORT SWITCH CONTROL ECU

E197647

a.

Disconnect the connector.


b.

Remove the bolt and driving support switch control ECU.