| Detection Item | Symptom | Trouble Area |
|---|---|---|
| Main Body ECU Communication Stop Mode | Either condition is met:
·
"Main Body" is not displayed on "Bus Check". ·
"Main Body ECU Communication Stop Mode" in "DTC Combination Table" applies. |
·
Power source or inside main body ECU (multiplex network body ECU) ·
Main body ECU (multiplex network body ECU) branch wire or connector ·
Main body ECU (multiplex network body ECU) |
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.
Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the CAN main wire and the CAN branch wire.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the airbag system.
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
NEXT
Disconnect the G64 main body ECU (multiplex network body ECU) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| G64-14 (CANH) - G64-13 (CANL) | Ignition switch off | 54 to 69 Ω |
| *a | Rear view of wire harness connector
(to Main Body ECU [Multiplex Network Body ECU]) |
OK
NG
Connect the cable to the negative (-) battery terminal.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
| *a | Rear view of wire harness connector
(to Main Body ECU [Multiplex Network Body ECU]) |
*b | Front view of wire harness connector
(to Main Body ECU [Multiplex Network Body ECU]) |
Remove the main body ECU (multiplex network body ECU) (See page Power Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G63-3 (GND2) - Body ground | Always | Below 1 Ω |
| A-11 (GND1) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A-31 (ALTB) - Body ground | Always | 11 to 14 V |
| A-30 (BECU) - Body ground | Always | 11 to 14 V |
| A-29 (ACC) - Body ground | Ignition switch ACC | 11 to 14 V |
| A-32 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
OK
NG