CHECK DRIVER SIDE JUNCTION BLOCK ASSEMBLY AND MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
| *A | for LHD | *B | for RHD |
Remove the main body ECU (multiplex network body ECU) (See page Power Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL).
Measure the voltage and resistance according to the value(s) in the table below.
Measure the values on the wire harness side with the connector disconnected.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| A-30 (BECU) - Body ground | - | Battery power supply | Always | 11 to 14 V |
| A-31 (ALTB) - Body ground | - | Battery power supply | Always | 11 to 14 V |
| A-32 (IG) - Body ground | - | Ignition switch power supply | Ignition switch ON | 11 to 14 V |
| A-32 (IG) - Body ground | - | Ignition switch power supply | Ignition switch off | Below 1 V |
| A-29 (ACC) - Body ground | - | ACC power supply | Ignition switch ACC | 11 to 14 V |
| A-29 (ACC) - Body ground | - | ACC power supply | Ignition switch off | Below 1 V |
| A-11 (GND1) - Body ground | - | Ground | Always | Below 1 Ω |
| G63-3 (GND2) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
| G64-17 (KSW) - Body ground | G - W-B | Unlock warning switch | No key in ignition key cylinder | 10 kΩ or higher |
| G64-17 (KSW) - Body ground | G - W-B | Unlock warning switch | Key inserted in ignition key cylinder | Below 1 Ω |
If the result is not as specified, there may be a malfunction in the wire harness.
Install the main body ECU (multiplex network body ECU).
Measure the voltage according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| 2I-27 (FLCY) - Body ground | R - Body ground | Front door LH courtesy switch input | Front door LH open | Below 1 V |
| 2I-27 (FLCY) - Body ground | R - Body ground | Front door LH courtesy switch input | Front door LH closed | 11 to 14 V |
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| 2H-26 (FRCY) - Body ground | B - Body ground | Front door RH courtesy switch input | Front door RH open | Below 1 V |
| 2H-26 (FRCY) - Body ground | B - Body ground | Front door RH courtesy switch input | Front door RH closed | 11 to 14 V |
If the result is not as specified, the main body ECU (multiplex network body ECU) or driver side junction block assembly may have a malfunction.