Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
69780B
1.INSTALL REAR DOOR INSIDE LOCKING CABLE ASSEMBLY LH
69740D
2.INSTALL REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH
69340
3.INSTALL REAR DOOR LOCK ASSEMBLY LH
When reusing the removed rear door lock assembly, replace the door lock wiring harness seal on the connector with a new one.
Do not allow grease or dust to adhere to the surface of the connector which contacts the door lock wiring harness seal.
Reusing the door lock wiring harness seal or using a damaged door lock wiring harness seal may allow water into the connection. This may result in a malfunction of the rear door lock assembly.
Apply MP grease to the sliding parts of the rear door lock assembly.
| *A | w/o Double Locking System |
| *B | w/ Double Locking System |
|
Slide |
Install a new door lock wiring harness seal to the rear door lock assembly.
Insert the rear door lock assembly into the rear door outside handle release plate, and set it on the rear door panel.
Check that the rear door outside handle frame release plate is securely connected to the rear door lock assembly.
Using a T30 "TORX" wrench, install the rear door lock assembly with the 3 screws.
68104
4.INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH
68124B
5.INSTALL REAR DOOR QUARTER WINDOW GLASS LH
67408E
6.INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH
68152C
7.INSTALL REAR DOOR GLASS RUN LH
67842E
8.INSTALL REAR DOOR SERVICE HOLE COVER LH
68174A
9.INSTALL REAR DOOR INNER GLASS WEATHERSTRIP LH
67604
10.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
74611C
11.INSTALL ASSIST GRIP COVER LH
69298C
12.INSTALL NO. 2 DOOR INSIDE HANDLE BEZEL LH
13.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).