69350
1.INSTALL BACK DOOR LOCK ASSEMBLY
When reusing the removed back door lock assembly, replace the door lock wiring harness seal on the connector with a new one.
Do not allow grease or dust to adhere to the surface of the connector which contacts the door lock wiring harness seal.
Reusing the door lock wiring harness seal or using a damaged door lock wiring harness seal may allow water into the connection. This may result in a malfunction of the front door lock assembly.
Connect the cable.
Install a new door lock wiring harness seal to the front door lock assembly.
Using a T30 "TORX" wrench, install the back door lock assembly with the 3 screws.
| *A | for Standard Type |
| *B | w/ Back Door Tire Carrier, for Face to Face Seat Type |
Connect the connector.
67847A
2.INSTALL BACK DOOR SERVICE HOLE COVER
69205F
3.INSTALL DOOR INSIDE HANDLE SUB-ASSEMBLY (w/ Back Door Tire Carrier, for Face to Face Seat Type)
64780A
4.INSTALL BACK DOOR TRIM PANEL ASSEMBLY
69783B
5.INSTALL BACK DOOR INSIDE HANDLE BEZEL (w/ Back Door Tire Carrier, for Face to Face Seat Type)
64798
6.INSTALL BACK DOOR LOCK COVER (w/o Back Door Tire Carrier, for Standard Type)
09120A
7.INSTALL TOOL CASE
75202B
8.INSTALL UPPER TOOL BOX PANEL SUB-ASSEMBLY
67761A
9.INSTALL BACK DOOR TRIM COVER
67938A
10.INSTALL BACK DOOR SIDE GARNISH LH
67937B
11.INSTALL BACK DOOR SIDE GARNISH RH
67939B
12.INSTALL CENTER BACK DOOR GARNISH