Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENTRY AND START SYSTEM (for Entry Function) › 2015.06–2017.08
RM27T0E _58 Vehicle Interior _053731 THEFT DETERRENT / KEYLESS ENTRY _0261053 ENTRY AND START SYSTEM(for Entry Function) J

THEFT DETERRENT / KEYLESS ENTRY  ENTRY AND START SYSTEM(for Entry Function)  Entry Interior Alarm does not Sound  


DESCRIPTION

The entry and start system uses the combination meter buzzer to perform various vehicle interior warnings. When the conditions of each warning are met, the certification ECU sends a buzzer signal to the combination meter assembly, and the combination meter buzzer sounds.

CAUTION / NOTICE / HINT

NOTICE:
·

The entry and start system (for Entry Function) uses a multiplex communication system (LIN communication system) and the CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENTRY AND START SYSTEM (for Entry Function)>HOW TO PROCEED WITH TROUBLESHOOTING). Troubleshoot the entry and start system (for Entry Function) after confirming that the communication systems are functioning properly.

·

Before replacing the certification ECU, refer to the Service Bulletin.



PROCEDURE

1.CHECK COMBINATION METER ASSEMBLY (OPERATION)
a.

Turn the engine switch on (IG). Place a weight of 20 kg (44.0 lb) on the passenger seat to cause the passenger seat belt warning light to blink.


b.

When driving the vehicle at 15 km/h (9.3 mph) or more, check that the seat belt warning buzzer sounds to inform that the passenger seat belt is not fastened.

HINT:

The entry and start system sounds the buzzer built into the combination meter for indoor warnings. This buzzer is also used for the seat belt warning system. Therefore, the operation of the combination meter buzzer can be checked by checking if the buzzer sounds to inform that the seat belt is not fastened.


OK:

Combination meter buzzer sounds.




OK

REPLACE CERTIFICATION ECU

NG