Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM › 2015.06–2017.08
RM27T0E _58 Vehicle Interior _053731 THEFT DETERRENT / KEYLESS ENTRY _0261054 THEFT DETERRENT SYSTEM J

THEFT DETERRENT / KEYLESS ENTRY  THEFT DETERRENT SYSTEM  Horn Circuit  


DESCRIPTION

When the theft deterrent system is in the alarm sounding state, the main body ECU outputs a signal repeatedly at 0.4 second intervals, causing the horns to sound.

WIRING DIAGRAM

B224123E16
4.93,1.806 6.604,2.158 1.674,0.352 10 Main Body ECU (Multiplex Network Body ECU) 5.076,0.821 5.263,0.991 0.187,0.170 10 28 5.346,0.959 5.835,1.142 0.489,0.184 10 HORN 1.925,0.83 2.039,1.000 0.114,0.170 10 7 0.96,1.643 1.833,1.795 0.872,0.153 10 1A 0.96,1.806 3.256,1.985 2.295,0.179 10 No. 1 Integration Relay (Horn Relay) 4.93,1.663 5.208,1.804 0.279,0.141 10 A

PROCEDURE

1.CHECK HORN OPERATION
a.

Press the horn switch and check if the horns sound.

OK:

Horns operate normally.




OK

2.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (VEHICLE HORN)

NG

2.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (VEHICLE HORN)
a.

Operate the intelligent tester according to the steps on the display and select Active Test (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>THEFT DETERRENT SYSTEM>DATA LIST / ACTIVE TEST).

Main Body
Tester Display Test Part Control Range Diagnostic Note
Vehicle Horn Vehicle horns ON/OFF -

OK:

Horns operate normally.




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

3.CHECK HARNESS AND CONNECTOR (NO. 1 INTEGRATION RELAY - MAIN BODY ECU)
3.CHECK HARNESS AND CONNECTOR (NO. 1 INTEGRATION RELAY - MAIN BODY ECU)
a.

Disconnect the 1A relay connector.


b.

c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1A-7 - A-28 (HORN) Always Below 1 Ω
1A-7 or A-28 (HORN) - Body ground Always 10 kΩ or higher




OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR