Home › Vehicle Interior › METER / GAUGE / DISPLAY › COMBINATION METER › 2015.06–2017.08
RM27T0E _58 Vehicle Interior _053733 METER / GAUGE / DISPLAY _0261081 COMBINATION METER A

METER / GAUGE / DISPLAY  COMBINATION METER  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 83100 1.INSTALL COMBINATION METER ASSEMBLY

a.

Connect the 2 connectors.


b.

Install the combination meter assembly with the 4 screws.


Hide 55404D 2.INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

a.

Connect the connector.


b.

Attach the 2 clips and 2 guides.


c.

Attach the 4 claws.


d.

Attach the 4 claws to install the instrument cluster finish panel sub-assembly.


Hide 55480D 3.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY

Hide 55476C 4.INSTALL INSTRUMENT PANEL FINISH PLATE GARNISH (for RHD)

Hide 55471A 5.INSTALL INSTRUMENT CLUSTER FINISH PANEL ORNAMENT (for LHD)

Hide 6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 7.RESTORE AUTOAWAY/RETURN FUNCTION (for Power Tilt and Power Telescopic Steering Column)

a.

Restore the Autoaway/Return function setting to the previous condition by changing the customize parameter (See page Steering>STEERING COLUMN>POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM>CUSTOMIZE PARAMETERS).