Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › REAR FLOOR AIRBAG SENSOR › 2015.06–2020.08
RM27T0E _58 Vehicle Interior _053735 SUPPLEMENTAL RESTRAINT SYSTEMS _0261093 REAR FLOOR AIRBAG SENSOR A

SUPPLEMENTAL RESTRAINT SYSTEMS  REAR FLOOR AIRBAG SENSOR  INSTALLATION  


PROCEDURE

Hide 89837A 1.INSTALL REAR FLOOR SIDE AIRBAG SENSOR

a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.

Install the rear floor airbag sensor with the bolt.

Torque:
9.0 N*m (92 kgf*cm, 80 in.*lbf)

NOTICE:
·

If the rear floor airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.

·

When installing the rear floor airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.




d.

Check that the rear floor airbag sensor is not loose.


e.

Connect the connector.


Hide 89839A 2.INSTALL REAR FLOOR SIDE AIRBAG SENSOR COVER

a.

Attach the clip and claw to install the cover.


b.

Return the floor carpet to its original position.


Hide 67934 5.INSTALL QUARTER SCUFF PLATE LH (w/ Rear No. 2 Seat)

Hide 67933 6.INSTALL QUARTER SCUFF PLATE RH (w/ Rear No. 2 Seat)

Hide 58371F 7.INSTALL REAR NO. 1 FLOOR STEP COVER (w/ Rear No. 2 Seat)

Hide 8.INSTALL REAR NO. 1 SEAT ASSEMBLY

a.

for 60/40 Split Double-folding Seat Type LH Side:



b.

for 60/40 Split Double-folding Seat Type RH Side:



c.

for 60/40 Split Tumble Seat Type LH Side:



d.

for 60/40 Split Tumble Seat Type RH Side:



e.

for 60/40 Split Slide Walk-in Seat Type LH Side:



f.

for 60/40 Split Slide Walk-in Seat Type RH Side:



Hide 9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 10.CHECK SRS WARNING LIGHT