Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
69065A
1.INSTALL AIRBAG CUTOFF SWITCH CYLINDER SUB-ASSEMBLY
Attach the 2 claws to install the cutoff switch cylinder.
55317A
2.INSTALL INSTRUMENT SIDE PANEL RH
3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
4.CHECK SRS WARNING LIGHT
Check the SRS warning light (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DIAGNOSIS SYSTEM).